  ![HS 4452 BF [3" dam] shower](http://ep.yimg.com/ca/I/wantasub1_2196_152969147)
 HS 4452 BF [3" dam] shower
We have eleven (10) right hand and three (2) left hand showers available as of 01-09-08. Call for availablitiy and shipping fees.
Sold without shower heads
Overall Dimensions Installed:
44"Wide x 52"Deep x 77" Height
Gel Coat finish
Flame spread rating of 200 or less
Smoke density rating of 450 or less per ASTM E84
Galvanized steel reinforced stiffeners
Extra reinforcing in all critical areas
Slip resistant floor
Built-in soap shelf
21" x 42" Satin finish stainless steel grab bar horizontally mounted
24" Satin finish stainless steel grab bar vertically mounted
folding wheelchair transfer
42" Satin finish stainless steel curtain rod installed
Drain is brass body, self-caulking with stainless steel strainer
Unit is packaged with cardboard on forklift pallet
Full LTL wooden shipping crate available as option
TITLE 24 compliant when equipped as shown and properly installed*
Hydro Systems HS 4452 BF [3" dam] shower with 5 year limited warranty, 44" Wide x 52" Deep x 77" High with folding wheelchair transfer seat conforming to Title 24 accessibility standard, 1" O.D. satin finish stainless steel curtain rod, 21"x42" satin finish stainless steel grab bar on wet wall and rear wall, center rear drain with rear sloping integrally molded slip resistant floor.
Units shall be molded of gel-coated fiberglass reinforced polyester resin.
Units shall meet or exceed physical and performance requirement for Type 2 gel-coated fixtures [of ANSI Z124.2 showers].
Standing/walking surfaces shall meet slip-resistance requirements of Consumer Safety Specification ASTM F-462, with static friction coefficient no less than 0.04.
Handicapped grab bars shall be nom. 1½" O.D. and support a minimum load of 250lbs. in accordance with the Consumer Safety Specification ASTM F-446 and ANSI A117.1 guidelines.
Units shall have a flame spread rating of 200 or less and a smoke density rating of 450 or less per ASTM E84.
Units shall bear or have affixed to them a molded manufacturer's logo and/or permanent label showing manufacturer's name and model number and the seal of the Uniform Plumbing Code and shall be accompanied by detailed installation recommendations.
|